Rhinoman Fitment Instructions for Ammo Box Rack – XP/XT/RhinoLite
Fitment Instructions
for Rhinoman
Ammo Box Rack
(Accessory)
XTREME, XPEDITION & RHINOLITE
Fitment Kit Contents
Description
Quantity
Illustration
A. Ammo box rack assembly
1
B. M8 x 20 Hexagonal screw
4
C. M8 Flat washer
4
D. M8 Nyloc nut
4
E. M6 x 20 Hexagonal screw (RhinoLite Only)
6
F. M6 Body washer (RhinoLite Only)
6
G. M6 Spring washer (RhinoLite Only)
6
Required Tools
Description
Illustration
13mm Spanner
13mm Socket
10mm Spanner (for fitment in a RhinoLite canopy)
10mm Socket (for fitment in a RhinoLite canopy)
Installation Time & Care Instructions
- Approx. 30 minutes.
⚠︎ Be aware of the edges on all sheet metal components and take extra care during handling.
⚠︎ Ensure that the area where the ammo box rack will be installed is free from any obstructions.
- Torque all M6 fasteners to 11.7 Nm
Torque all M8 fasteners to 28.4 Nm - The fitment of the ammo box rack will require two people.
Fitment Steps
Step 1
- Remove the most outer (fitment) brackets from the ammo box rack assembly, by loosening the M8 nyloc nuts at the bottom of each bracket. Fig. 2.2.1
- Ensure not to misplace the removed M8 nyloc nuts, as you will need to use them again.
Step 2
- FOR XP/XT CANOPY FITMENT: Install 2 x M8 x 20 Hexagonal screws into the bottom side rail on the left-and-right-hand side of the canopy. Fig. 2.3.1
- Align the screws with the illustrated slots in the fitment bracket then push the bracket against the rail and hold in position. Fig. 2.3.2
- Fasten the bracket in place with 1 x M8 flat washer and 1 x M8 nyloc nut over each screw.
Repeat the process for the opposite side. Fig. 2.3.3 - FOR RHINOLITE CANOPY FITMENT: Align the dedicated slots with three M6 riv-nuts pre-installed in the canopy. Fig. 2.3.4
- Fix the bracket in place with 1 x M6 x 20 hexagonal screws, 1 x M6 spring washer, and 1 x M6 flat washer in each M6 riv-nut. Fig. 2.3.5
Step 3
Prior to placing the ammo box rack onto the previously installed fitment brackets, ensure that both brackets are in line with one another.
- Place the ammo box rack onto the fitment brackets, with the bolts at the bottom entering the dedicated slots in the fitment brackets. Fig. 2.4.1
- Position the ammo box center to the canopy, then secure the ammo box rack to the fitment brackets by fastening all 16 x screws with 1 x M8 flat washer and 1 x M8 nyloc nut each. Fig. 2.4.2
Step 4
- You have now successfully completed the fitment of your Rhinoman ammo box rack.
- Confirm that all the fitment screws have been properly tightened one last time.
- Be sure to check at least bi-monthly that all the screws are still properly tightened.