Rhinoman Fitment Instructions for Nissan NP300 Single Cab
Fitment Instructions
for Nissan
NP300
Single Cab
RHINOLITE
Fitment Kit Contents
Description
Quantity
Illustration
M8 x 25 Bolt
4
M8 Nylock Nut
4
M8 Flat Washer
4
M8 Body Washer
4
Required Tools
Description
Illustration
13mm Spanner
13mm Socket Wrench (Optional)
Marker
Drill
Ø9 Drill Bit
Installation Time & Care Instructions
- Approx. 45 Minutes (Excluding the removal of any accessories from load bin)
- Before installation, ensure that your hands and workwear are clean from oil, grime & dirt.
- Ensure that the correct tools and PPE are used whilst installing the canopy. Clean the rear cab window before fitting the canopy.
- Torque all M8 fasteners to approx. 28Nm.
Fitment Steps
Step 1
- Unpack all fasteners from packaging: ensure that everything is accounted for as indicated above.
- Prepare all required tools as listed above.
Step 2
- Remove any cab guards, roll bar, tonneau cover, sports bar etc. from vehicle.
- Ensure that the rear cab window of the vehicle is clean, before loading the canopy onto the load bin.
Step 3
- Fit the canopy to the loading bin, align & space evenly, with a minimum distance of 25mm between the front panel of the canopy and the cab.(Fig. 1)
- Mark and drill a Ø9mm hole in each corner of the canopy right through the vehicle load box, in line with the center of the load box edge.
- Once all 4 x corners are drilled, secure the canopy to the load box using the bolts supplied, with the body washer on the top, and flat washer below.
Step 4
- Trim sealing rubber on tailgate with knife or scissors.
- Check again for alignment of canopy on sides of loading bin.
- Check all bolts one final time.
- Enjoy your NEW Rhinoman all Aluminum Canopy.
WARRANTY, SERVICE & CARE GUIDE
- All Rhinoman products carry a comprehensive 2-year factory warranty.
- PLEASE NOTE: Your canopy will only be covered under warranty if it has been fitted by an approved Rhinoman fitment centre or agent.
- Please do inspect the fasteners on the fitment brackets every once in a while, to ensure that all bolts are still tight and properly secured.