Rhinoman Fitment Instructions for Table Hanger – RhinoLite
Fitment Instructions
for Rhinoman
Table Hanger
(Accessory)
RINOLITE
Fitment Kit Contents
Description
Quantity
Illustration
A. Table hanger frame
1
B. Front bracket
1
C. XP/XT Right hand rear bracket
D. XP/XT Left hand rear bracket
E. RhinoLite Right hand rear bracket
1
F. RhinoLite Left hand rear Bracket
1
G. M8 x 20 Hexagonal screw
8
H. M8 Flat washer
8
I. M8 Spring washer
8
J. M8 Nyloc nut
Required Tools
Description
Illustration
1 x 13mm Spanner
1 x 13mm Socket
Installation Time & Care Instructions
- Approx. 20 minutes.
⚠︎ Be aware of the edges on all sheet metal components and take extra care during handling.
⚠︎ Ensure that the area where the table hanger will be installed is free from any obstructions.
⚠︎ Ensure that the area where the table hanger will be installed is free from any obstructions.
- Torque all M8 fasteners to 28.4 Nm.
- The fitment of the table hanger will require two people.
Fitment Steps
Step 1
- For packaging purposes, the rear fitment brackets are assembled the wrong way around. Fig. 3.1.1
- Taking note of the fastener sequence, disassemble both the rear fitment brackets, then re-assemble the brackets in the opposite positions using the same fastening sequence. Fig. 3.1.2
Step 2
- Identify the dedicated screw positions. Fig. 3.3.1
- With one person handling the front and one person handling the rear of the hanger, place the hanger against the roof, with the slots in both the front and rear fitment brackets aligning with the dedicated screw positions. Fig. 3.3.2
- Secure the table hanger in position with 1 x M8 flat washer, 1 x M8 spring washer and 1 x M8 x 20 in each dedicated screw position. Fig. 3.3.3
Step 3
- You have now successfully completed the fitment of your Rhinoman table hanger.
- Confirm that all the fitment screws have been properly tightened one last time.
- Be sure to check at least bi-monthly that all the screws are still properly tightened.